2019 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Front Side Door Latch 10 N.m (89 lb in)
Front Side Door Lock Striker Bolt 25 N.m (18 lb ft)
Front Side Door Outside Bracket Screw 5 N.m (44 lb in)
Front Side Door Outside Handle Insert Screw 1.5 N.m (13 lb in)
Front Side Door Outside Handle Lock Cylinder Bezel Screw 10 N.m (89 lb in)
Rear Compartment Lid Latch Bolt 9 N.m (80 lb in)
Rear Compartment Lid Latch Striker Fastener 9 N.m (80 lb in)
Rear Side Door Latch 10 N.m (89 lb in)
Rear Side Door Lock Striker Bolt 22 N.m (16 lb ft)
Rear Side Door Outside Bracket Screw 5 N.m 44 lb in
Rear Side Door Outside Handle Insert Screw 1.5 N.m (13 lb in)
Rear Side Door Outside Handle Lock Cylinder Opening Cover Screw 4.7 N.m (42 lb in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.