2018 Cadillac CTS Base, AWDFACTORY OEM SERVICE PROCEDURE

Calibration Procedure

NOTE:

To complete the battery sensor module calibration, there must be no significant parasitic electrical drain on the battery. If the parasitic electrical drain does not remain below 100 mA during vehicle rest, the calibration will not be completed successfully. Refer to Battery Electrical Drain/Parasitic Load TestΒ 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.