Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fastener Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Transfer Case Input Shaft Front (Outer) Seal |
| Transfer Case Input Shaft Rear Seal |
| Transfer Case Idler Gear Shaft Rear Seal |
| Transfer Case Idler Gear Shaft Front Seal |
| Transfer Case Rear Extension Housing-To-Transfer Case Seal |
| Transmission-to-Transfer Case O-ring Seal |
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Transfer Case Drain Plug | 40 N.m (30 lb ft) |
| Transfer Case Fill Plug | 40 N.m (30 lb ft) |
| Transfer Case Rear Extension Housing Bolt | |
|
25 N.m (18 lb ft) |
|
130 degrees |
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Transfer Case Bracket-to-Engine Bolts | 22 N.m (16 lb ft) |
| Transfer Case Bracket-to-Rear Extension Housing Bolts | 58 N.m (43 lb ft) |
| Transfer Case-to-Transmission Bolts | 110 N.m (81 lb ft) |
| Transfer Case Rear Output Shaft Flange Bolt | 35 N.m (26 lb ft) |
| Transfer Case Vent | 25 N.m (18 lb ft) |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.