2017 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Power Steering System - DTCS

POWER STEERING SYSTEM DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC Description
DTC C0176 Control Module Temperature Sensor High Temperature
DTC C0450 Steering Assist Control Actuator Circuit (NXC)
DTC C0460 Steering Wheel Angle Sensor
DTC C0475 Electric Steering Motor Circuit Malfunction
DTC C047A Electric Steering Motor Position Sensor Circuit Malfunction
DTC C0544 Steering Wheel Angle Sensor Signal Not Plausible
DTC C0545 Steering Wheel Torque Sensor Malfunction
DTC C055C Steering Gear Performance Malfunction
DTC C0569 Internal Check Sum Error/Calibration Not Programmed/Configuration Not Programmed (NXC)
DTC C0569 Internal Check Sum Error/Calibration Not Programmed/Configuration Not Programmed (NJ2)
DTC C056D Electronic Control Unit Hardware
DTC C056D Electronic Control Unit Hardware (Power Steering Control Module)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.