Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE
Antilock Brake System - DTCS
ANTILOCK BRAKE SYSTEM DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B0000 | Vehicle Speed Information Circuit |
| DTC B2745 | Traction Control Switch Circuit Short to Ground |
| DTC C0035, C0040, C0045, or C0050 | Wheel Speed Sensor Circuits |
| DTC C0060, C0095, C0121, C0141, C0146, C0151, or C0156: | Antilock Braking System Solenoids/Valve Relay Circuits/Traction Control Front Prime Solenoid Valves/Traction Control Isolation |
| DTC C0110 | Pump Motor |
| DTC C0131 | Traction Control System Pressure Circuit |
| DTC C0161 | Antilock Braking System Brake Switch Circuit |
| DTC C0186, C018B, C0196, C019B, C027E, or C0287 | Lateral Acceleration Sensor Signal/Yaw Rate Signal/Longitudinal Acceleration Sensor Signal (With UGN) |
| DTC C0186, C0196, or C0287 | Lateral Acceleration Sensor Signal/Yaw Rate Signal/Longitudinal Acceleration Sensor Signal (Without UGN) |
| DTC C025F, C0274, C0275, or C0280 | Brake Master Cylinder Inlet and Isolation Valves/Isolation Valve/Dump Valve/Stability System Active Too Long |
| DTC C0710 | Steering Position |
| DTC C124F, C1250, or C1251 | Lateral Acceleration Sensor |
| DTC P0856 | Traction Control Torque Request Signal Message Counter Incorrect |
| DTC P1513 | Traction Control Drag Reduction Request Circuit |
| DTC P15F8 | Automatic Braking Engine Torque Request Signal Message Counter Incorrect |
| DTC P15FD | Wheel Speed Sensor Message Sequence Incorrect |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
