2017 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Windshield Replacement: Notes

Special Tools

  • BO-24402-AΒ  Glass Sealant Remover (Cold Knife)
  • BO-39032Β  Stationary Glass Removal Tool
  • Use an adhesive that is approved by GM Specification GMW-15672

For equivalent regional tools, refer to Special ToolsΒ 

    NOTE:

    Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

  1. Open the hood.
  2. Remove the windshield wiper arms and blades. Refer to Windshield Wiper Arm Replacement .
  3. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement
  4. Remove the windshield garnish moldings. Refer to Windshield Garnish Molding Replacement .
  5. Remove the rearview mirror. Refer to Inside Rearview Mirror Replacement .
  6. Disconnect the rain sensor connector, if equipped.
  7. WARNING:

    If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

  8. Cover to protect the following parts from broken glass:
    • Upper dash pad
    • Defroster outlets and A/C outlets
    • Seats and carpeting
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.