2017 Cadillac XT5 BaseFACTORY OEM SERVICE PROCEDURE

Steering Column Lock Control Module Replacement

Fig 1: Steering Column Lock Control Module
GM4254524Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. With the vehicle in accessory mode, remove fuse to unlock the steering column lock control module. Refer to Steering Wheel Schematics 
  2. Remove Steering Column. Refer to Steering Column Replacement (N37) Steering Column Replacement (N38) 
1 Steering Column Lock Control Module Bolt - Rear (Qty: 2)
CAUTION:

Refer to Fastener Caution .

Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.