Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Cadillac XT5 BaseFACTORY OEM SERVICE PROCEDURE
Antilock Brake System - DTCS
ANTILOCK BRAKE SYSTEM DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B0000 | Vehicle Speed Information Circuit |
| DTC B2745 | Traction Control Switch Circuit |
| DTC C0035-C0050 | Wheel Speed Sensor |
| DTC C0110 | Pump Motor Circuit Malfunction |
| DTC C0131 | Traction Control System Pressure Circuit |
| DTC C0161 | Antilock Braking System Brake Switch |
| DTC C0186, C0187, C018A, C018B, C0196, C019A, C019B, C027E, C027F, or C0287 | Acceleration Sensor/Yaw Rate Signal |
| DTC C0242 | Powertrain Control Module Indicated Traction Control |
| DTC C0245 | Wheel Speed Sensor Frequency Malfunction |
| DTC C0274, C0275, or C0280 | Valve High Temperature/Stability System Active Too Long |
| DTC C0558 | Calibration Data Configuration Not Programmed |
| DTC C0561 | System Disabled Information Stored |
| DTC C0710 | Steering Wheel Angle Signal |
| DTC C124F or C1250-C1254 | Acceleration Sensor |
| DTC P0856 | Traction Control Torque Request Signal Message Counter Incorrect |
| DTC P15F8 | Automatic Braking Engine Torque Request Signal Message Counter Incorrect |
| DTC P15FD | Wheel Speed Sensor Message Sequence Incorrect |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.