2017 Cadillac XT5 BaseFACTORY OEM SERVICE PROCEDURE

Engine Control Module Bracket Replacement

Fig 1: Engine Control Module Bracket
GM4290995Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Reposition away Radiator Surge Tank Inlet Hose @ Engine Control Module Bracket. Refer to Radiator Surge Tank Inlet Hose Replacement (LGX From Surge Tank To Radiator and Pipe)Radiator Surge Tank Inlet Hose Replacement (Radiator Surge Tank Outlet Pipe to Engine Coolant Air Bleed Pipe, LGX)
  2. Remove Engine Control Module. Refer to Engine Control Module Replacement 
1 Engine Control Module Bracket Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Engine Control Module Bracket
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.