Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Cadillac XT5 BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.Β |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Battery Hold Down Retainer Bolt | 22 N.m (16 lb ft) |
| Battery Hold Down Retainer Fastener (Above Battery) | 9 N.m (80 lb in) |
| Battery Negative Cable Ground Fastener (Engine Block-LGX) | 40 N.m (30 lb ft) |
| Battery Negative Cable Frame Ground Fastener | 9 N.m (80 lb in) |
| Battery Negative Cable Nut (Battery Sensor) | 12 N.m (106 lb in) |
| Battery Negative Post Clamp Nut | 4.5 N.m (40 lb in) |
| Battery Positive Cable Conduit Fastener (Starter) | 9 N.m (80 lb in) |
| Battery Positive Cable Nut-Large (Fuse Block) | 12 N.m (106 lb in) |
| Battery Positive Cable Nut-Small (Fuse Block) | 9 N.m (80 lb in) |
| Battery Positive Cable Nut(Generator) | 15 N.m (11 lb ft) |
| Battery Positive Cable Nut(Starter) | 12.5 N.m (111 lb in) |
| Battery Positive Junction Block Cable Nut | 12 N.m (106 lb in) |
| Battery Positive Post Clamp Nut | 4.5 N.m (40 lb in) |
| Battery Tray Mounting Bolt | 22 N.m (16 lb ft) |
| Generator Bolt(LGX) | 22 N.m (16 lb ft) |
| Starter Mounting Bolt(LGX) | 58 N.m (43 lb ft) |
| Starter Heat Shield Fastener | 9 N.m (80 lb in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
