Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Cadillac XT5 BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Generator (2) » Install
- Generator Bolt (1) Install and tighten [2x] 22 N.m (16 lb ft)
- Drive Belt Idler Pulley (2) » Install - Drive Belt Idler Pulley Replacement
- Electrical Connector (4) » Connect
- Battery Positive Cable (1) » Install
- Battery Positive Cable Nut (2) @ Generator » Install and tighten 15 N.m (11 lb ft)
- Protective Cap (3) » Install
- Install the drive belt. (1) » Install - Drive Belt Replacement
- Air Conditioning Refrigerant Pressure Sensor (1) » Install - Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement
- Front Bumper Fascia (3) » Install - Front Bumper Fascia Replacement
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
CAUTION:
Refer to Fastener Caution
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
