2017 Cadillac CTS Base, AWDFACTORY OEM SERVICE PROCEDURE

Sunroof Window Replacement (Front)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sunroof Window & Screws - Front
GM2752546Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Front Sunroof Window Screw (Qty: 4)
CAUTION: Refer to Fastener Caution .

Procedure

  1. Open the sunshade to the full open position.
  2. Place the sunroof in the vent position to access the screws.
  3. Reposition sunroof seal as needed to access screws.
  4. Lift the sunroof window out of the frame.

Tighten 
5 N.m (44 lb in)
2 Front Sunroof Window

Procedure

  1. Sunroof window height and opening fit adjustment. Refer to Sunroof Window Height and Opening Fit Adjustment .
  2. Water test to ensure that sunroof window and window seal is fitting properly in the close position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.