Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Re-Initialization/Teach Procedure
Start with the Glass in the closed position and "Glass Close" switch released. Press and hold the "Glass Close" switch for approximately 10 seconds, then the glass will de-initialize the roof. The glass panel shall move toward the "Front hard-stop" and stall for 400 milliseconds (0.4 seconds), then back-up slightly to the full close soft stop. The shade shall automatically move toward the "Front hard-stop" and stall for 400 milliseconds (0.4 seconds), then back-up slightly to the shade panel full close soft stop. This completes the initialization. After the shade panel has moved to the soft stop, release the switch, then press and hold the "Glass Close" switch to re-teach the glass and shade. Once the teach process is completed, both glass and shade will be at full close.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.