Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Cadillac CTS Base, AWDFACTORY OEM SERVICE PROCEDURE
Section 217 (Object Detection System And Pedestrian Protection System - Repair Instructions)
WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Repair Instructions
- Front Seat Lane Departure Warning Actuator Replacement
- Forward Range Radar Module Replacement
- Short Range Radar Sensor Replacement
- Pedestrian Impact Detection Sensor Replacement - Front Upper Beam
- Active Hood Hinge Actuator Replacement
- Active Safety Control Module Replacement
- Forward Collision Alert Display Replacement
- Pedestrian Impact Detection Module Replacement
- Pedestrian Impact Detection System Handling and Scrapping
- Parking Assist Control Module Replacement
- Advance Parking Assist Alarm Sensor Replacement
- Front Parking Assist Alarm Sensor Replacement
- Side Object Sensing Alert Module Replacement
- Rear Parking Assist Alarm Sensor Replacement
- Multifunction Relay Module Bracket Replacement
- Vehicle Performance Camera Replacement
- Vehicle Performance Camera Bracket Replacement
- Side View Driver Information Camera Replacement
- Front View Camera Replacement (With UFL)
- Front View Camera Replacement (With UGN)
- Front View Camera Replacement (With UQT)
- Front View Driver Information Camera Replacement (CTS)
- Front View Driver Information Camera Replacement (CTS-V)
- Front View Driver Information Camera Bracket Replacement
- Rearview Driver Information Camera Replacement
- Front View Camera Module Calibration
- Repairs and Inspections Required After a Collision (B3T)
- Radar Sensor Module - Long Range Calibration
- Video Processing Module Replacement
- Video Processing Control Module Calibration
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
