Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2017 Cadillac CTS Base, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Fig 1: Wireless Charging System Module And Bracket Bolt

Courtesy of GENERAL MOTORS COMPANY

Install Wireless Charging System Module (2)

CAUTION:

Fastener Caution

Install Wireless Charging System Module Bracket Bolt (1) (Qty: 4) and tighten to 1 N.m (9 lb in)
Connect the electrical connector.

Fig 2: Instrument Panel Center Compartment Liner And Wireless Charging System Module Bracket Bolt

Courtesy of GENERAL MOTORS COMPANY

Install Wireless Charging System Module Bracket (3)
Install Wireless Charging System Module Bracket Bolt (2) (Qty: 2) and tighten to 1 N.m (9 lb in)
Install Instrument Panel Center Compartment Liner (1)

Chapter Navigation

Return to Chapter: Wireless Charging System Module Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.