2016 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Application Specification
Metric English
Power Steering Assist Motor Pivot Bolt (Requires a NEW bolt.)  22 N.m 16 lb ft
Power Steering Fluid Cooler Bracket Bolt 9 N.m 80 lb in
Power Steering Fluid Reservoir Bracket Bolt 9 N.m 80 lb in
Power Steering Fluid Reservoir Inlet Hose Fitting @ Power Steering Fluid Cooler 34 N.m 25 lb ft
Power Steering Gear Inlet and Outlet Hose Bolt 9 N.m 80 lb in
Power Steering Gear Inlet Hose @ Power Steering Pump 34 N.m 25 lb ft
Power Steering Gear Inlet Hose and Outlet Pipe Bracket Nut 9 N.m 80 lb in
Power Steering Gear Inlet Hose Bolt @ Power Steering Pump 50 N.m 37 lb ft
Power Steering Gear Inlet Hose Bracket Bolt-Bracket @ Engine 58 N.m 43 lb ft
Power Steering Gear Inlet Hose Bracket Bolt-Hose @ Bracket 9 N.m 80 lb in
Power Steering Gear Inlet Hose Connector 34 N.m 25 lb ft
Power Steering Gear Outlet Hose Fitting @ Power Steering Fluid Cooler 34 N.m 25 lb ft
Power Steering Pump Bolt 22 N.m 16 lb ft
Power Steering Pump Bracket Bolt-Long 58 N.m 43 lb ft
Power Steering Pump Bracket Bolt-Short 22 N.m 16 lb ft
Steering Gear Bolt (Requires a NEW bolt.) 
  • First Pass:
 110 N.m 81 lb ft
  • Final Pass:
 150-165 degrees
Steering Gear Heat Shield Bolt 9 N.m 80 lb in
Steering Gear Housing Cover Bolt (M6) (Requires a NEW bolt.)  10 N.m 89 lb in
Steering Gear Housing Cover Bolt (M8) (Requires a NEW bolt.)  22 N.m 16 lb ft
Steering Gear Pipe 19 N.m 14 lb ft
Steering Gear Pipe Retainer Bolt 12 N.m 106 lb in
Steering Linkage Inner Tie Rod 100 N.m 74 lb ft
Steering Linkage Outer Tie Rod Nut
  • First Pass:
 35 N.m 26 lb ft
  • Final Pass:
 30-45 degrees
Chapter Navigation
Return to Chapter: Specifications
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.