2016 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Wireless Charging System Module And Bolt
    GM4211309Courtesy of GENERAL MOTORS COMPANY
  1. Install Wireless Charging System Module (2)
  2. Install Wireless Charging System Module Bolt (1) (Qty: 4) and tighten to 1 N.m (9 lb in)
    3. Fig 2: Wireless Charging System Module Bracket And Bolt
    GM4211306Courtesy of GENERAL MOTORS COMPANY
  3. Install Wireless Charging System Module Bracket (2)
  4. Connect the electrical connector.
  5. Install Wireless Charging System Module Bracket Bolt (1) (Qty: 2) and tighten to 1 N.m (9 lb in)
    6. Fig 3: Instrument Panel Center Compartment Liner
    GM4211301Courtesy of GENERAL MOTORS COMPANY
  6. Install Instrument Panel Center Compartment Liner (1)
  7. Close the climate control system panel.
Chapter Navigation
Return to Chapter: Wireless Charging System Module Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.