Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Power Steering Fluid Cooler Bracket Bolt | 9 N.m | 80 lb in |
| Power Steering Fluid Cooler Inlet and Outlet Hose Bracket Bolt | 9 N.m | 80 lb in |
| Power Steering Fluid Reservoir Bolt | 9 N.m | 80 lb in |
| Power Steering Fluid Reservoir Bracket Bolt | 9 N.m | 80 lb in |
| Power Steering Gear Inlet Hose Bracket Fastener | 9 N.m | 80 lb in |
| Power Steering Gear Inlet Hose Fitting | 34 N.m | 25 lb ft |
| Power Steering Gear Outlet and Reservoir Inlet Hose Bracket Fastener | 9 N.m | 80 lb in |
| Power Steering Gear Outlet Pipe and Hose Bracket Fastener | 9 N.m | 80 lb in |
| Power Steering Gear Outlet Pipe and Hose Fitting | 34 N.m | 25 lb ft |
| Power Steering Pump Bolt | 22 N.m | 16 lb ft |
| Steering Gear Heat Shield Fastener | 9 N.m | 80 lb in |
| Steering Gear Nut | ||
|
60 N.m | 44 lb ft |
|
120Β° | |
| Steering Gear Pipe Retainer Fastener | 12 N.m | 106 lb in |
| Steering Gear Valve Solenoid Bolt - Lower | ||
|
0.5 N.m | 4.4 lb in |
|
2.9 N.m | 25.7 lb in |
| Steering Gear Valve Solenoid Bolt - Upper | ||
|
1.5 N.m | 13.3 lb in |
|
2.9 N.m | 25.7 lb in |
| Steering Linkage Inner Tie Rod | 70 N.m | 52 lb ft |
| Steering Linkage Outer Tie Rod Nut | ||
|
25 N.m | 18 lb ft |
|
90Β° | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
