2016 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Application Specification
Metric English
Brake Pipe Fitting 19 N.m 14 lb ft
Brake Pressure Modulator Valve (BPMV) Bracket Bolt 12 N.m 106 lb in
BPMV Bracket Nut 10 N.m 89 lb in
Electronic Brake Control Module (EBCM) Bolt 3 N.m 27 lb in
Master Cylinder Heat Shield Bolt 10 N.m 89 lb in
Master Cylinder Heat Shield Nut 25 N.m 18 lb ft
Wheel Speed Sensor Bolt- Front and Rear 9 N.m 80 lb in
Yaw Sensor Nut 7 N.m 62 lb in
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.