2016 Cadillac ELRFACTORY OEM SERVICE PROCEDURE

Chassis Control Module Replacement

Fig 1: Fuel Pump Flow Control Module
GM2381246Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the rear compartment floor stowage trim compartment. Refer to Rear Compartment Floor Stowage Trim Compartment Replacement .
  2. Reposition the rear portion of the rear compartment side trim - right side. Refer to Rear Compartment Side Trim Replacement - Right Side .
1 Chassis Control Module Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Chassis Control Module
Procedure 
If replacing, reprogram the control module. Refer to Control Module References .
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.