2016 Cadillac ELRFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Wireless Charging System Module Bolt
    GM4259408Courtesy of GENERAL MOTORS COMPANY
  1. Install Wireless Charging System Module (2)
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install Wireless Charging System Module Bolt (1) (Qty: 4) and tighten to 1 N.m (9 lb in)
    3. Fig 2: Wireless Charging System Module Bracket Bolt
    GM4259407Courtesy of GENERAL MOTORS COMPANY
  3. Install Wireless Charging System Module Bracket (2)
  4. Connect the electrical connector.
  5. Install Wireless Charging System Module Bracket Bolt (1) (Qty: 2) and tighten to 1 N.m (9 lb in)
    6. Fig 3: Instrument Panel Center Compartment Liner
    GM4259406Courtesy of GENERAL MOTORS COMPANY
  6. Install Instrument Panel Center Compartment Liner (1)
  7. Close the climate control system panel.
Chapter Navigation
Return to Chapter: Wireless Charging System Module Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.