Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Calibration (with UGN)
New modules must be SPS programmed prior to calibration , refer to Control Module References
The calibration process for the front view camera system is necessary when a front view camera module is replaced by a new one. This process shall not be required when only replacing the windshield and the front view camera module has been mounted again properly. This process shall be completed within 10-30 minutes when the correct driving conditions are met. If the Lane Departure Warning Switch is pressed during calibration, the indictor will flash momentarily and then stay out - this is normal operation.
Once SPS programming is complete, it is necessary to initiate the calibration using a scan tool. During this time the "Service Driver Assist" service message will be displayed.
To calibrate the front camera, operate the vehicle in the following conditions until the calibration is complete:
- Clean windshield.
- Avoid aggressive and frequent lane changes. Occasional lane changes are preferred.
- Maintain vehicle speeds between 56-120 km/h (35-75 MPH).
- Ensure the road contains visible references (well defined lane markings, etc.).
Once the procedure is complete, the service message will turn off and normal operation will resume. Shortly after the green ready to assist light should turn on as long as all conditions are met for normal operation. The system is then ready to assist.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
