2014 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Radio Control Assembly Replacement

WARNING: This page is about a different car, the 2013 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radio Control Assembly & Fasteners
GM2756924Courtesy of GENERAL MOTORS COMPANY
Radio Control Assembly Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel - center. Refer to Instrument Panel Trim Panel Replacement - Center
  2. Remove the instrument panel - right side. Refer to Instrument Panel Trim Panel Replacement - Right Side .
  3. Remove the accessory switch. Refer to Accessory Switch Replacement .
  4. Remove the hazard warning switch. Refer to Hazard Warning Switch Replacement .
1 Radio Control Fasteners (Qty: 6)
CAUTION:

Refer to Fastener Caution .

2 Radio Control Assembly

Procedure

  1. Disconnect the electrical connections.
  2. When replacing the radio control assembly, transfer all necessary components.
  3. Refer to Control Module References for programming and setup information.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.