2014 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE

Component Testing

Dynamic Test

  1. Disconnect the harness connector at the S3 Transmission Shift Lever.
  2. Verify the M7 Transmission Shift Lock Control Solenoid Actuator activates.
    • If the M7 Transmission Shift Lock Control Solenoid Actuator does not activate.Β 

      Replace the S3 Transmission Shift Lever.

    • If the M7 Transmission Shift Lock Control Solenoid Actuator does activate.Β 
  3. All OK
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.