2014 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE

Reference Information

Schematic Reference

Object Detection Schematics 

Connector End View Reference

COMPONENT CONNECTOR END VIEWS - INDEX

Description and Operation

Object Detection Description and Operation (with Active Safety System, UGN, N America) , Object Detection Description and Operation (with Front and Rear Park Assist, UD5) , Object Detection Description and Operation (with Rear Park Assist, UD7) , Object Detection Description and Operation (with Side Blind Zone Alert, UFT, N America) , Object Detection Description and Operation (with Rear Cross Traffic Alert, UFG, N America) , Object Detection Description and Operation (with Forward Collision Alert, UEU) , Object Detection Description and Operation (with Lane Departure Warning, UFL) , Object Detection Description and Operation (with Haptic Signal Motor Seat) , Object Detection Description and Operation (with Adaptive Cruise Control, KSG, N America) , Object Detection Description and Operation (with Active Safety System, UGN, except N America) , Object Detection Description and Operation (with Adaptive Cruise Control, KSG, except N America) , Object Detection Description and Operation (with Side Blind Zone Alert, UFT, Except N America) , Object Detection Description and Operation (with Rear Cross Traffic Alert, UFT, Except N America) 

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.