Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Cadillac ELRFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 6.10 OZS. | 0.18 L | POE | S | |||
| Air Cond Refrigerant | 2.10 LBS. | 0.95 KG | R-134a | S | |||
| Brake Fluid | N/A | N/A | DOT 3 Hydraulic Brake Fluid | S | |||
| Engine Coolant | Engine Coolant Fluid | 7.70 QTS. | 7.28 L | 50/50 mixture of DEX-COOL and deionized water | S | ||
| Engine Coolant | High Voltage Battery Pack Cooling | 6.40 QTS. | 6.05 L | 50/50 mixture of DEX-COOL and deionized water | S | ||
| Engine Coolant | Power Electronics Cooling | 3.00 QTS. | 2.83 L | 50/50 mixture of DEX-COOL and deionized water | S | ||
| Engine Oil | w/Filter | 3.70 QTS. | 3.5 L | API - SAE 5W-30 | Use only engine oil licensed to the dexos1 specification, or equivalent, of the proper SAE viscosity grade. ACDelco dexos1 Synthetic Blend is recommended. DO NOT use other viscosity oils such as SAE 10W-30, 10W-40, or 20W-50. In an area of extreme cold, where the temperature falls below -29Deg.C (-20Deg.F), an SAE 0W-30 oil should be used. | S | |
| Fuel Tank | 9.30 GALS. | 35.2 L | S | ||||
| Windshield Washer Fluid | N/A | N/A | Windshield Washer Fluid | Follow the Manufacturer's Instructions for the mixture ratio. Automotive windshield washer fluid that meets regional freeze protection requirements. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.