2014 Cadillac ELRFACTORY OEM SERVICE PROCEDURE

Charge Port Housing Replacement

Fig 1: Charge Port Housing
GM3511242Courtesy of GENERAL MOTORS COMPANY
Charge Port Housing Replacement

Callout Component Name
WARNING:

Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure includes the following steps:

  • Identify how to disable high voltage.
  • Identify how to test for the presence of high voltage.
  • Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.

Before working on any high voltage system, be sure to wear the following Personal Protection Equipment:

  • Safety glasses with appropriate side shields when within 15 meters (50 feet) of the vehicle, either indoors or outdoors.
  • Certified and up-to-date Class "0" Insulation gloves rated at 1000V with leather protectors.
    • Visually and functionally inspect the gloves before use.
    • Wear the Insulation gloves with leather protectors at all times when working with the high voltage battery assembly, whether the system is energized or not.

Failure to follow the procedures may result in serious injury or death.

Preliminary Procedures

  1. Disable the high voltage system. Refer to High Voltage Disabling .
  2. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  3. Disconnect the electrical connector for the charge port door ajar indicator switch assembly.
  4. Remove the charge port door. Refer to Charge Port Door ReplacementΒ .
  5. Remove the charge port housing bezel. Refer to Charge Port Housing Bezel ReplacementΒ .
1 Charge Port Housing Assembly

Procedure

  1. From inside the fender, release the lower tab to the charge port housing assembly (arrow).
  2. Push outward on the assembly housing.
  3. Using a plastic trim-type stick, at the arrows, gently pry outward while pulling outward on the rear edge of the housing.
  4. Rotate the rear edge of the housing forward, pull the housing and seal from the front fender center reinforcement bracket.
  5. Remove the charge port housing assembly along with the electrical harness for the charge port door ajar indicator switch assembly and charge port door actuator cable assembly.
  6. Transfer the charge port door ajar indicator switch assembly. Refer to Charge Port Door Ajar Indicator Switch ReplacementΒ .
  7. Enable the high voltage system. Refer to High Voltage Enabling .
NOTE:

Upon the final assembly of the charge port housing into the front fender center reinforcement bracket, ensure to re-seat the charge port housing seal around the entire circumference of the charge port receptacle. Use a blunt tool such as a rounded plastic trim tool to push the seal into position around the charge port receptacle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.