2014 Cadillac ELRFACTORY OEM SERVICE PROCEDURE

Circuit/System Testing

  1. Ignition ON
  2. Verify that DTC C018C 3A is not set.
    • If the DTC is set 
    1. Install the correct part number multi-axis acceleration sensor. Clear DTCs and retest.
      • If the DTC returns, replace the K14 Distance Sensing Cruise Control Module.
      • If the DTC does not return
    2. All OK.
    • If the DTC is not set 
  3. All OK.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.