Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Replace and Program Control Module
The steering column position control module does not require SPS programming but does require the following setup procedures after a new control module is installed:
- Ignition ON.
- Perform the Steering Column Tilt Wheel and Telescope Control Module Learn. Refer to Steering Column Tilt Wheel and Telescope Control Module Learn
- With a scan tool, Clear All DTCs .
If equipped with RPO A45, Seat Memory Control Module, perform the next step.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.