2013 Cadillac XTS AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Fuel Tank Module & O-Ring
    GM2205628Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW seal (2) and the fuel tank module (1).
  2. Fig 2: Fuel Pump Vent Hose
    GM2817600Courtesy of GENERAL MOTORS COMPANY
  3. Connect the fuel pump vent hose to the fuel tank fuel pump module. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Fig 3: Lock Ring
    GM2205627Courtesy of GENERAL MOTORS COMPANY
  5. Use the CH 45722   wrench by turning clockwise and install the lock ring (1).
  6. Fig 4: Fuel Pump Electrical Connectors
    GM2817602Courtesy of GENERAL MOTORS COMPANY
  7. Connect the fuel pump electrical connector (1) and the quick connects (2). Refer to Plastic Collar Quick Connect Fitting Service .
  8. Install the fuel tank. Refer to Fuel Tank Replacement (FWD) , Fuel Tank Replacement (AWD) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.