Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
- Ignition ON. Radio ON.
- Verify DTC U0028 is set.
- If the DTC is set
Refer to DTC U0028 .
- If the DTC is not set
- If the DTC is set
- Verify DTC U0029 is not set with symptom byte 02.
- If DTC U0029 is set with symptom byte 02
Refer to DTC U2098 .
- If DTC U0029 is set with other symptom bytes except 02
- If DTC U0029 is set with symptom byte 02
- Refer to Testing for Intermittent Conditions and Poor Connections to test for an intermittent condition.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
