2013 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE

Circuit/System Verification

  1. Ignition ON. Radio ON.
  2. Verify DTC U0100-U02FF is set.
    • If the DTC is not set 
  3. Verify DTC U2098 or DTC U0029 02 is set.
    • If any of the DTCs are set 

      Refer to DTC U2098 .

    • If none of the DTCs are set 
  4. Verify DTC U0028 is set.
    • If the DTC is set 
    1. Access the A11 Radio's Last Working MOST ID of Node 1-9 parameters with a scan tool to view MOST device location IDs and MOST bus configuration.
    2. Access the A11 Radio's Surrogate MOST Master Node Upstream Position parameter with a scan tool to determine the surrogate MOST Master device and where the MOST ring break occurs. For more information, refer to Diagnostic Aids  section.
    3. Refer to Circuit/System Testing .
    • If the DTC is not set 
  5. All OK.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.