Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Cadillac SRX BaseFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Remove the fuel tank. Refer to Fuel Tank Replacement .
- Disconnect the electrical connector (1).
- Disconnect the evaporative emission line (2). Refer to Plastic Collar Quick Connect Fitting Service .
- Using the CH 48482 wrench , remove the cam lock ring (1) by turning counterclockwise.
- Partially raise the secondary fuel pump module and disconnect the crossover tube (1) by pulling back the plastic retaining tab (2).
- Disconnect the evaporative emission line (1). Refer to Plastic Collar Quick Connect Fitting Service .
- Remove the secondary fuel tank module (1) and the O-ring (2).
WARNING:
Refer to Gasoline/Gasoline Vapors Warning .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.