Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Cadillac SRX FWDFACTORY OEM SERVICE PROCEDURE
Fuel Injector Replacement: Notes
Special Tools
- EN-47909 Injector Bore and Sleeve Cleaning Kit
- EN-48266 Injector Seal Installer and Sizer
- GE-6125-1B Slide Hammer
- EN 3721-A Injector Remover
- EN 39313 Spark Plug Port Adapter
For equivalent regional tools, refer to Special Tools (Diagnostic Tools)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.