2012 Cadillac SRX AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install the following components if fuel tank replacement was necessary:
  2. Fig 1: View Of Fuel Tank, Strap & Bolts
    GM2232228Courtesy of GENERAL MOTORS COMPANY
  3. Raise the fuel tank (3) to the vehicle.
  4. CAUTION:

    Refer to Fastener Caution .

  5. Ensure the fuel tank straps are seated properly. Install the fuel tank straps (2) and bolts (1) then tighten to 45 N.m(33 lb ft).
  6. Fig 2: Identifying Evaporative Emission Line & Canister
    GM2232219Courtesy of GENERAL MOTORS COMPANY
  7. Connect the evaporative emission line (1) to the canister.
  8. Fig 3: Identifying Fuel Tank Electrical Connector
    GM2232206Courtesy of GENERAL MOTORS COMPANY
  9. Connect the fuel tank electrical connector (1).
  10. Connect the fuel line and evaporative emission line connectors (2). Refer to Plastic Collar Quick Connect Fitting Service .
  11. Fig 4: View Of Evaporative Emission Line
    GM2232203Courtesy of GENERAL MOTORS COMPANY
  12. Connect the evaporative emission line (1). Refer to Plastic Collar Quick Connect Fitting Service .
  13. Install the filler tube and tighten the hose both clamp (2) to 5 N.m(44 lb in).
  14. Perform a leak down test. Refer to Evaporative Emission System Diagnosis .
  15. If required, install the propeller shaft. Refer to Propeller Shaft Replacement .
  16. Install the exhaust system. Refer to Exhaust Muffler Replacement .
  17. Refill the fuel tank.
  18. Inspect for fuel leaks.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.