2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Power Take-Off (PTO) Component Views

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Frame Rail
GM1870627Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 X300
2 G300
3 Automatic Transmission Turbine Speed Sensor
4 Automatic Transmission Input Shaft Speed (AT ISS) Sensor
5 Automatic Transmission
6 Vehicle Speed Sensor (VSS)
7 X124
8 Power Take Off (PTO) Module
9 X175
Fig 2: Front of the I/P -YE9
GM1855926Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Driver Information (DIC) Switch
2 Instrument Panel Cluster (IPC)
3 Radio
4 Ambient Light/Sunload Sensor Assembly (CJ2) / Ambient Light Sensor (C67/C42)
5 HVAC Control Module
6 Inflatable Restraint I/P Module Disable Switch (C99)
7 Power Take-Off (PTO) Switch
8 Auxiliary Power Outlet - Front 2
9 I/P Multifunction Switch Assembly
10 Auxiliary Power Outlet - Front 1
11 Transfer Case Shift Control Switch (NQF/NQH)
12 Trailer Brake Control Panel Switch (JL1)
13 Headlamp and Panel Dimmer Switch
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.