2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Scan Tool Data Definitions: Inputs

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Accessory Switch:Β  The scan tool display if the ignition switch is in the accessory state or not.

Cargo Door Ajar Switch:Β  Passenger van only. The scan tool displays the position of the cargo door. The scan tool displays On when the door is open.

Driver Door Ajar Sw.:Β  The scan tool displays the position of the driver's door. The scan tool displays On when the door is open.

Passenger Door Ajar Sw.:Β  Passenger van only. The scan tool displays the position of the passenger or the rear door. The scan tool displays On when either door is open.

Run/Crank:Β  The scan tool displays the position of the ignition switch. The scan tool displays On when the ignition switch is in the RUN or CRANK position.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.