2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Stator Coil

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using DVOM, check for continuity between the stator coil leads. See Fig 1. If continuity exists, go to next step. If continuity does not exist, replace stator.
  2. Verify that there is no continuity between the stator coil leads and the core. If continuity exists, replace the stator coil. See Fig 2.
Fig 1: Testing Stator Continuity (Typical)
G00211661Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.