2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Generator Control Module Scan Tool Information

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Starter/Generator Control Module Scan Tool Data Parameters

Parameter System State Expected Value Description
Operating Conditions:  Ignition ON
APM Control Mode - Off The scan tool displays Off, High to Low, Low to High or Not Used. This is the state of the auxiliary power module (APM) control mode.
APM Control Status - Charging The scan tool displays Charging, Current Limited, Shutdown or Not Used. This is the auxiliary power module (APM) control status.
Desired APM Voltage - Varies This displays Volts. This is the desired auxiliary power module (APM) voltage.
Generator Starter Field Current - Varies This displays amps.
Generator Starter Field Current - Enable The scan tool displays Enable or Disable. This is the current state of the generator starter field.
Hill Hold Solenoid 1 - Varies This displays %.
Hill Hold Solenoid 2 - Varies This displays %.
Hill Hold Solenoid Relay - Varies This displays Enable or Disable. This is the current state of the hill hold solenoid relay.
Hood Position - Closed The scan tool displays Open or Closed. This is the current position of the hood switch.
Hybrid System Voltage - Varies This displays Volts. This is the current hybrid system voltage.
SGCM 12 Volt Converter - Varies This displays amps.
SGCM Converter Temperature - Varies This displays °C (°F). This is the current starter/generator control module (SGCM) converter temperature.
SGCM Internal Temperature - Varies This displays °C (°F). This is the current starter/generator control module (SGCM) internal temperature.
SGCM Inverter Temperature - Varies This displays °C (°F). This is the current starter/generator control module (SGCM) inverter temperature.
Starter Generator Speed - Varies This displays RPM.
Starter Generator Temperature - Varies This displays °C (°F).
Starter/Generator Control Module Scan Tool Output Controls

Output Control Description
Brake Hold Sol. 1 This output control commands the brake hold solenoid 1 ON and OFF.
Brake Hold Sol. 2 This output control commands the brake hold solenoid 2 ON and OFF.
SGCM Field Current This output control commands the starter/generator control module (SGCM) field current ON and OFF.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.