2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: This condition may be caused by low vehicle battery voltage. If the battery is not sufficiently charged (above 10 volts), the system will have difficulties detecting the fob and the ELECTRONIC KEY NOT DETECTED message will be displayed. Correct the low battery voltage condition to eliminate this condition.
  1. With the vehicle locked, attempt to passively unlock and enter the vehicle by approaching the vehicle with a valid transmitter and pulling the exterior door handle. The door should unlock and open.
  2. While placing the keyless entry transmitter in various locations within the vehicle interior, verify the vehicle does not start.
    • If the vehicle starts, inspect for any sources of RF interference such as cell phone chargers, power supplies, etc. that would interrupt transmitter and antenna communication.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.