Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the left hood hinge actuator.
- Ignition ON, test for less than 1 volt between the high control circuit terminal A and ground.
- If greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the PIDS module.
- Test for less than 1 volt between the low control circuit terminal B and ground.
- If greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the PIDS module.
- Ignition OFF, test for infinite resistance between the high control circuit terminal A and ground.
- If not the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the PIDS module.
- Test for infinite resistance between the low control circuit terminal B and ground.
- If not the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the PIDS module.
- Test for less then 1 ohm of resistance between the high control circuit terminal A and ground.
- If not within the specified range, test the circuit for an open/high resistance.
- Test for less then 1 ohm of resistance between the low control circuit terminal B and ground.
- If not within the specified range, test the circuit for an open/high resistance.
- If all circuits test normal, replace the hood hinge actuator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
