Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Circuit/System Testing
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect harness connectors at all rear object sensors.
- Ignition ON, transmission in REVERSE, test for 8.0-9.0 volts between object sensor supply voltage circuit terminal 1 and ground.
- If less than the specified range, test the supply voltage circuit for a short to ground. If all circuits test normal, replace the object alarm module.IMPORTANT: A short to voltage on the component signal circuit may cause this DTC to set.
- If greater than the specified range, test the supply voltage circuit for a short to voltage. If all circuits test normal, replace the object alarm module.
- If less than the specified range, test the supply voltage circuit for a short to ground. If all circuits test normal, replace the object alarm module.
- Connect each rear object sensor one at a time, while monitoring Sensor Feed Voltage Output scan tool parameter. The parameter value should be greater than 8.0 volts.
- If less than the specified value after an individual object sensor is connected, test or replace that object sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
