2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: View Of Engine Harness Retainer Nut & Electrical Connectors
    GM1696891Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and ConnectionΒ .
  2. Remove the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  4. Disconnect the engine harness electrical connector (3) from the generator.
  5. Fig 2: View Of Battery Jumper Cable Terminal, Nut & Bolt
    GM1702914Courtesy of GENERAL MOTORS COMPANY
  6. Reposition the generator battery jumper cable boot (3).
  7. Remove the battery jumper cable nut (2) from the generator.
  8. Remove the battery jumper cable terminal (1) from the generator stud.
  9. Fig 3: View Of Generator & Bolts
    GM1702916Courtesy of GENERAL MOTORS COMPANY
  10. Remove the generator bolts.
  11. Remove the generator.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.