2012 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: View Of Battery Cable & Current Sensor
    GM1702510Courtesy of GENERAL MOTORS COMPANY
  1. Remove the negative battery cable. Refer to Battery Negative Cable ReplacementΒ .
  2. Mark the location of the battery current sensor on the battery cable with tape for reference during installation.
  3. Remove the tape securing the battery current sensor to the negative battery cable.
  4. Mark the location of the negative battery cable clips (1) and remove the clips from the cable.
  5. Squeeze the negative battery cable branches together.
  6. IMPORTANT:

    Note the orientation of the battery current sensor prior to removal.

  7. Slide the battery current sensor (2) off of the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.