2012 Cadillac Escalade AWD V8-6.2LFACTORY OEM SERVICE PROCEDURE

Connecting Rod, Engine

Connecting Rod
Connecting Rod Bearing Clearance - Production 0.023-0.065 mm (0.0009-0.0025 in)
Connecting Rod Bearing Clearance - Service 0.023-0.076 mm (0.0009-0.003 in)
Connecting Rod Bore Diameter - Bearing End 56.505-56.525 mm (2.224-2.225 in)
Connecting Rod Bore Out-of-Round - Bearing End - Production 0.004-0.008 mm (0.00015-0.0003 in)
Connecting Rod Bore Out-of-Round - Bearing End - Service 0.004-0.008 mm (0.00015-0.0003 in)
Connecting Rod Side Clearance 0.11-0.51 mm (0.00433-0.02 in)
Connecting Rod Bolts
Tighten the bolts a first pass to 20 Nm (15 lb ft)
Tighten the bolts a final pass 85 degrees
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.