WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Wheel Control Switch Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Remove the horn switch. Refer to Steering Wheel Horn Switch Replacement .
1	Steering Wheel Trim Cover (Qty: 2) Procedure: Remove the 4 horn contact screws.
2	Steering Wheel Control Switch Assembly Screw (Qty: 4) CAUTION: Refer to Fastener Caution . Tip: Quantity may vary with vehicle options. Tighten: 1 N.m (9 lb in)
3	Steering Wheel Control Switch Assembly (Qty: 2) Tip: Quantity may vary with vehicle options. Ensure the steering wheel control switch(es) are properly seated to the steering wheel shroud during installation.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Steering Wheel Control Switch Assembly Replacement

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?