Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2011 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Steering Wheel Control Switch Assembly Replacement

Fig 1: Steering Wheel Control Switch Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Remove the horn switch. Refer to Steering Wheel Horn Switch Replacement .
1	Steering Wheel Trim Cover (Qty: 2) Procedure Remove the 4 horn contact screws.
2	Steering Wheel Control Switch Assembly Screw (Qty: 4) CAUTION: Refer to Fastener Caution . TIP: Quantity may vary with vehicle options. Tighten 1 N.m (9 lb in)
3	Steering Wheel Control Switch Assembly (Qty: 2) Quantity may vary with vehicle options. Ensure the steering wheel control switch(es) are properly seated to the steering wheel shroud during installation.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.