SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 794 (DATA COMMUNICATION SYSTEM)VISUAL IDENTIFICATIONDATA COMMUNICATION CONNECTORSBODY CONTROL MODULE (BCM) C1
2011 Cadillac Escalade Base, AWD

Body Control Module (BCM) C1

2011 Cadillac Escalade Base, AWDSECTION Body Control Module (BCM) C1
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) C1 Connector End View
GM1664495Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) C1 Connector Parts Information

Connector Part Information 
  • OEM: 15482789
  • Service: 88988838
  • Description: 27-Way F Receptacle 0.64 2.8 (L-GN)
Terminal Part Information 
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: 12094429/J-35616-64B (L-BU)
Body Control Module (BCM) C1 Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 - - Not Used
2 PK 1020 Ignition 0 Voltage
3 GY 1884 Cruise Control Switch Signal
4 WH 530 5-Volt Reference
5 L-GN 1715 Windshield Wiper Switch High Signal
6 L-GN 6818 Steering Wheel Control Switch Signal
7 - - Not Used
8 TN/BK 6009 Low Reference
9 L-BU 1714 Windshield Wiper Switch Low Signal
10-13 - - Not Used
14 PK 3 Ignition 1 Voltage
15 D-GN 663 Hazard Switch Left Turn Signal
16 TN 664 Hazard Switch Right Turn Signal
17 PK 1444 12-Volt Reference
18 YE 525 Headlamp Dimmer Switch Signal
19 WH 111 Hazard Switch Signal
20 PU 5526 Tap Up/Tap Down Switch Signal (MYC)
21 BN 4 Ignition 1 Voltage
22 - - Not Used
23 L-BU 553 Tow/Haul Switch Signal
24 PK 94 Windshield Washer Switch Signal
25 YE 307 Headlamp Flash to Pass Signal
26 TN/WH 816 A/T Shift Lock Solenoid Supply Voltage
27 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.