Rear View Camera Replacement (Liftgate)

2011 Cadillac Escalade Base, AWDSECTION Rear View Camera Replacement (Liftgate)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Object Camera & Screws
GM1707642Courtesy of GENERAL MOTORS CORP.
Rear View Camera Replacement (Liftgate)

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the rear liftgate applique. Refer to Liftgate Center Applique Replacement (Escalade) or Liftgate Center Applique Replacement (Tahoe, Yukon) .
1 Rear Object Camera Screws

Tighten:  2 N.m (18 lb in)

2 Rear Object Camera
Tip:  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.