SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 774 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSREAR OBJECT ALARM MODULE SWITCH REPLACEMENT (ESCALADE)
2011 Cadillac Escalade Base, AWD

Rear Object Alarm Module Switch Replacement (Escalade)

2011 Cadillac Escalade Base, AWDSECTION Rear Object Alarm Module Switch Replacement (Escalade)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Object Alarm Module Switch Assembly
GM1703994Courtesy of GENERAL MOTORS CORP.
Rear Object Alarm Module Switch Replacement (Escalade)

Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
Preliminary Procedure: 
Remove the instrument panel accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement (Cadillac) or Instrument Panel Accessory Trim Plate Replacement (Except Cadillac) .
1 Rear Object Alarm Module Switch Assembly
Tip: 
  1. Disconnect the electrical connector.
  2. Use a small flat-bladed tool to release the locking tabs on the switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.